One True God Iron-on Logo (Pack of 10)
Pack of 10
ID 1241090
Logo for heat transfer to a T-shirt for use on the front or back of a T-shirt. Pack 10 (1-up on 10 sheets). 8.5” x 11” sheets. Transfer size: 7.5” x 8.5”
Application Instructions:
1. This transfer is not recommended for nylon, tightly woven fabrics, or dry-clean-only garments! Prewashing your garment is suggested. For best results, use 100% cotton garments. Garment must contain at least 50% cotton.
2. Preheat hand iron to setting between cotton and linen. If using a steam iron, remove all water from the iron.
3. Use a hard, clean, smooth work surface protected with a thin towel. A heat-resistant countertop in the kitchen is an excellent choice. DO NOT USE AN IRONING BOARD.
4. Iron garment to remove wrinkles, and then smooth out. Do not apply transfer over buttons or seams. Place transfer-side down at desired location on garment.
5. Irons with aluminum sole plates can cause black residue to appear around your design. To prevent this from happening, cover the transfer with a piece of copier paper. Residue may wash out.
6. Iron transfer one section (the width of your iron) at a time, side to side. Iron each section for 30 seconds, pressing firmly and constantly moving iron back and forth. NOTE: More than 30 seconds at a time can cause discoloration. Do not move iron in a circular motion.
7. Iron entire transfer again, but this time from top to bottom. Press firmly, constantly moving the iron back and forth for 30 seconds per section.
8. Seal outside edgest by pressing down firmly with iron on outermost transfer lines. SEALED EDGES ARE IMPORTANT.
9. Before removing the paper, let the garment cool until it is not warm to the touch. BE PATIENT! The transfer must be cool. If transfer does not release from paper or has not penetrated the fabric, replace the transfer paper and repeat step 7 (be sure to cover the iron-on completely with the transfer paper).
10. Save transfer paper until the garment has been washed several times. If the transfer was not properly applied, repeat steps 6, 7, and 8.
DO NOT re-iron directly over the surface of an applied transfer. If your garment must be pressed or you want to apply other transfers to the same garment, cover any exposed imprints with transfer paper.
Commercial Equipment Application Instructions:
1. Set heat to 350F.
2. Preheat garment 7 to 10 seconds.
3. Dwell time is 12 seconds, using medium pressure.
4. Cool and peel off transfer backing.
Washing Instructions:
If garment is machine washable, turn garment inside out. Wash in COOL water, tumble dry at lowest dryer setting or line dry. Do not bleach. Do not iron directly on design.
